kitepaster.blogg.se - N1mm logger through usb to serial port

N1MM LOGGER THROUGH USB TO SERIAL PORT INSTALL
N1MM LOGGER THROUGH USB TO SERIAL PORT DRIVER

The Icom 7300 N1MM Logger should be displaying the radio frequency at the top of the window next to the icon. Go back and verify the above settings and make sure your com ports are correct. If you do, something is not setup correctly.

Click OK to close the Configurer window.

Mine is DTR (pin 4)=CW, RTS (pin 7)=Always Off, Radio Nr=1, PTT Delay (msec)=30, Dig Wnd Nr=1, Allow ext interrupts and Winkey go UNchecked, Two Radio Protocol=None and Footswitch (pin 6)=None.

Next to that check Digi and also check CW/Other.

The next row under Port, choose the COM port your USB cable is connected to.

Footswitch (pin 6)=None and Radio Polling Rate=Normal. Mine is 9600, N, 8, 1, DTR (Pin4)=CW, RTS (pin 7)=PTT, Icom Code (hex)=94, Radio Nr=1, PTT Delay=30 and PTT via Radio Command SSB Mode is checked.

Make sure your Com port is setup correctly.

On the Hardware tab select the port that your CI-V cable is on and next to it choose the IC-7300 for the Radio.

Click on Config, then select Configure Ports, Mode Control, Audio, Other….

N1MM LOGGER THROUGH USB TO SERIAL PORT INSTALL

Step four, if you don’t already have it, download and install N1MM Logger+. It’s free and you can find it here. I have included a couple of extra settings that will help later on when using PSK31, RTTY (FSK) and CW keying. Set the following menu items under MENU>SET>Connectors. These are the changes, leave everything else to default settings. Step three, turn your radio on and setup the Icom 7300 using the radio’s menu. Do not connect the USB cable until you have downloaded and installed the driver.

N1MM LOGGER THROUGH USB TO SERIAL PORT DRIVER

Step one, if you haven’t already, download and install the USB driver from Icom for your Icom IC-7300. You can click on in the upper right for a very brief help menu. Select a WK com port identified by WKscan. Only the currently active USB com ports are shown.

Click on Setup and the com port selection list is shown. Cannot use logger at same time rig has just one. If you just want to use a USB Cable with HRD and operate some PSK31 or RTTY (AFSK), take a look at this video. All you need to do to get started is to configure the serial communications port. USB cable provides one virtual serial port In IC-7300 SET > Connectors menu: Set USB Keying (CW) to DTR-or-Set USB Keying (RTTY) to DTR Set USB Send to RTS Logging Software, rig control Port (USB), set DTRCW, RTSPTT In MMTTY, use EXTFSK or EXTFSK64 to select COM port. I have found this to be the easiest, because later on I added cw keying and RTTY (FSK) to the mix. select AFSK as the MMTTY mode for both DI-1 and DI-2. Select the Digital Modes tab in the N1MM Logger Configurer. Install MMTTY in two different directories on your hard disk. Use the CI-V for rig control and the USB for the soundcard. necessary to define 'Digital' ports on the N1MM 'Hardware' tab or FSK ports in Router. One is the USB cable connected to the radios USB port and the other is a CI-V cable connected to the radios CI-V port.